CHANGING A NEEDLE:
Turn off the power switch.
Holding the grip (A), insert the needle into the needle clamp and push it up as far as ti will go. Then tighten the needle clamp screw firmly while keeping the holder in place.



NEEDLE THREADING:
1. Turn off the power switch.

2. Hold the grip (A) of threader with mark (B) up. Guide the thread, inserting it into the Y-groove (C) of the knob from right to left.

3. Place the V-groove (D) ober the needle just above the needle eye.

4. Slide the threader down the needle while pushing it gently until the threader pin goes into the needle eye.

5. Push the grip (A)

6. Remove the threader from the needle slowly. Then pick up the loop with the hook (E) pulling the end of the thread out to the back.

Made in Taiwan.